SEANSON'S GREETINGS OF HOTLINK
SEANSON'S GREETINGS OF HOTLINK
SEANSON'S GREETINGS OF HOTLINK
Posted By: Hotlink Admin
Viewcount 14
SEANSON'S GREETINGS OF HOTLINK
Read More
HAS installation
HAS installation
HAS installation
Posted By: Hotlink Admin
Viewcount 237
Three steps for installtion of HAS Hotlink Automatic Splice
Step 1: Preparation
Measure the conductor for full insertion one half the length of HAS and indicate with tape or mark pen Wire brush the end section thoroughly with a bristle wire brush
Step 2: Installation
Insert conductor into splice with a smooth straight thrust through the jaws until conductor hits center stop.Do not push conductor partially in and do not twist.
Step 3:inspection
Before release blocks, apply a momentary "hand set" tension to make sure proper jaw gripping It is normal the conductor will move 1/4 to 1/2 inch out
due to the sliding action of grippled jaws while tension is applied.
Read More
HAS application in State Grid of China
HAS application in State Grid of China
HAS application in State Grid of China
Posted By: Hotlink Admin
Viewcount 131
In State Grid of China, the workers already very familiar with HAS products. In this video, we can see they cut the broken conductor with a sessor very quickly & then insert the conductor inside splice with a noise of "Ka-La" to complete the job.
This video shows the most value of HAS, it means time saving, cost saving, connection stable & reliable, results easy achieve. Why not contact us now for more information?
Read More
HAS Practice in Vicious Environment
HAS Practice in Vicious Environment
HAS Practice in Vicious Environment
Posted By: Hotlink Admin
Viewcount 136
HAS establish good using pratice when apply to vicious environment, for example in this video, the work site is in area of mountain & valley.
To repair broken overhead conductors in vicious environment, the workers should carry a lot of tools & equipments to climb mountains & valley, across streams, pass wild shrubbery or afforestation when it was broken by thunder, by flood or debris flow, by hurricans or storms when using old technology & parts.
HAS perform great advantages by its' easy carry, light weight, simple tools for work, reliable connecting quality. General cost of mat. & labour can save a lot with efficiency arise 50% at least !
Read More
HAS Operation Site Trainning
HAS Operation Site Trainning
HAS Operation Site Trainning
Posted By: Hotlink Admin
Viewcount 142
Before using HAS splice, the operator should peel suitable length of conductor, use tools to clean & repair tip of conductor to smooth, then catch the conductor insert into the splice for connection. when the operator hear a voice of "ka-la" means the connection operation is half done. then the operator should try to pull out conductor from splice to exam the result of connection work.
In the video, HAS shows very strong features of easy train to use, easy operation with stable/reliable connection for overhead power conductor.
Read More